Preform Dies

Preform Patented dies are produced and licensed from the UK and offer the Extruder significant advantages over Conventional Dies.

The basis of their performance is significantly reduced friction by using Zero Bearing technology with Preform control to allow successful extrusion of numerous shapes and sizes of Profile.

The Dies are generally suitable for production of Solid and Hollow Profiles with wall thicknesses within the range of 0.5mm up to 2mm. The extruder attains major benefits when extruding Profiles with wall thickness up to 1.5mm, however the Extruder will see advantages over Conventional Dies with wall thicknesses up to 2mm.

If as an Extruder you already produce volume thin walled sections Preform Dies can significantly improve the productivity and performance of your extrusion operation.

If as an Extruder you do not currently produce thin walled sections, due to a fear of poor performance, then Preform Dies will allow you to enter this growing market segment and allow you to produce Thin Walled Sections at better than acceptable rates.

Our Dies have for the past 10 years increased the performance of Extrusion Plants worldwide and enabled them to be more competitive in their particular marketplace.

Preform Dies are suitable for all section types, below are some products amongst many that Preform Dies could be utilised for:

  • Shower enclosures
  • Partitioning
  • Standard profiles
  • Automotive
  • Any section up to 2mm thick.
  • Architectural products
  • Kitchen trims
  • Carpet edging and door bars
  • Heating-air conditioning vents
  • Thin walled tubes
The Advantage of innovative Die Designs